Page 1 of 1
New member West Yorkshire.
Posted: Fri Jul 10, 2026 9:53 am
by Weg
Very warm welcome to Philpot1 In West Yorks.
Happy times with Triking.
Tony
Re: New member West Yorkshire.
Posted: Fri Jul 10, 2026 1:36 pm
by Philpot1
Hi Tony. Thanks. Its taken 3 months for me to get on the forum as i had to go through Alan layzell. I sent numerous emails but i didn't get any replies
Re: New member West Yorkshire.
Posted: Fri Jul 10, 2026 6:51 pm
by Richard and Pat
Welcome to the Forum Philpot1.
Let us know if you need any advice.
All the best.
Rich
Re: New member West Yorkshire.
Posted: Sat Jul 11, 2026 9:15 am
by Philpot1
Hi, Richard & Pat. I have a type 2 Triking, the engine is off a 1995 Moto Guzzi California 1100 EFI & the o/s/f wheel bearings rumbling & needs replacing. Are they BMC mini wheel bearings? Also i have a leaking rear bevel drive, the leak is coming from the drive shaft end. Do you know what part number it is for the seal. I could only assume the rear bevel is off the same bike as the engine. any info is much appreciated. many thanks Phil
Re: New member West Yorkshire.
Posted: Sat Jul 11, 2026 12:35 pm
by Richard and Pat
I cannot help with the bearings but there should be a number on them to use for ordering at a local bearing place. However Alan sells them at Triking so check your price before using the bearing shop.
If you trawl the internet for Moto Guzzi 1995 California parts list you will get the right item. Gutsibits will have them I imagine. Excellent service experienced with them.
Re: New member West Yorkshire.
Posted: Mon Jul 13, 2026 9:51 am
by Philpot1
Thanks guy's for the info
Re: New member West Yorkshire.
Posted: Mon Jul 13, 2026 12:40 pm
by Weg
Simple point, the drive end should be higher than the bevel box end to minimise oil running forward.