forum2.trikingsportscars.co.uk

Hi, Sorry I missed this question, If its not too late and depending on how far you have got with it......... We have done dozens like this and has proved the quickest and easiest............ The best way to remove the engine bolt from the (bike) frame assuming you have tried all the usual methods an...

This outstanding Type 2 Special has just been reduced in price for a quick sale due to property move.
http://shop.trikingsportscars.co.uk/pro ... ification/

We now have a Type 2 available, 1100EFI, Covered under 3000 miles, Just serviced, current MOT, ready to go, which we are offering for sale on behalf of owner - just reduced in price for a quick sale http://shop.trikingsportscars.co.uk/product/blue-ty2/

Triking T2 for sale on behalf of owner, Kit built to a good spec and high std (owner / builder is an engineer) Low mileage EFI 1100cc engine. Registered in 2013, not had much use. Numerous stainless parts. Currently located in North UK. Can be seen on our website under "For sale" section £17,000 con...

Hi, We use Wrightform in Eye Suffolk and C3 in Derham (Norfolk) also Laserfast near Kings Lynn are pretty helpfull, These are local to us but I am sure they would post a small part anywhere. If its a small machining / fabrication job we could probably do it here economically.... Let us know if you g...

Maybe worth considering that the cockpit on a T4 is significantly larger than all other models and the entry / exit process much easier !

Also - its is VERY important you fit the bearing spacer in the hub between the 2 wheel bearings, The purpose of the spacer is to allow the wheel axle to be fully tight without placing any side load on the bearings. Depending on the type of donor wheel you have it is sometimes necessary to shorten th...

Hi Kristoffer. We just press the bearings in to the hub at room temperature, If it makes it easier you can put the bearing in the freezer and heat the hub in the oven - about 20 minutes at around 150 degrees C should do it. The hub to wheel connection can be either way around - they are made with an...

A few Type 2's had the groove removed as a special order as requested by the customer. Either to gain slightly more internal space or purely for appearance.