forum2.trikingsportscars.co.uk

Thank you Mark

The Breva guzzi exhaust header pipes are 44mm od.
Does anyone know what size the system Alan supplies is ?

Happy one to you too.

Ah right good idea.

Fine. I used HSS tool to face and part off, with no problems. Drilling the bolt hole very slowly with plenty of cutting fluid.
I’ll harden and temper as advised.

Hi Richard
I have made a spacer as the other was worn and pitted. Made from 18mm dia tool steel. As the spacer only rotates back and forth I assume tool steel will be hard enough or do you think I should harden it ?

Hi Richard
When you say the "steel spacer" is that the steel tube that the bolt goes through ? If so no, its hardened and ground. I've yet to extract the bearings hopefully tomorrow so will update progress.
Are you on FB I'll post photos there the file is too large here.

Hi Richard
Should be straightforward so long as not seized as I found, probably no grease on assembly.
I've a couple of photos I can send if useful.
David

Thanks Tony thats good to know. Be good to get lots of data on Triking set ups, it will certainly help me.

I have been looking for information on understeer and oversteer tuning. I’ve listed some changes that can be tried. Hope it’s useful.