Search found 13 matches
Hope all you Trikers are well. I have fitted my pedal assembly and in view of the fact that I am rather short, 5feet4inches, I am still concerned that reaching the pedals will be challenging, even after I fitted 2inch extenders in between the master cylinders and the bias bar. I would like to know w...
Congrats. Very good result and a nice colour combination. When I upholstered something for my car in vinyl and got creases on the corners I removed them by using my wife's hairdryer, not heat gun. It's amazing how it stretches
Thank you for the replies and the photos attached. As regards photos I tried to make it smaller but still did not manage. I do not think it is possible with an iPad. I find this very frustrating as I would like to have suggestions from Trikers who have been through this before. However up to now I a...
I have today started laying down the Guzzi harness and have fitted the fuse panel and rectifier on the top of the glovebox. Is this ok. From what I can see I think the bonnet will be clear enough. I am going to try and put of photo on this thread. Sorry I am getting a message file too large
Thank you for the photos. That's a very good idea to have a shut off valve and I shall install one . i have almost completed loosely fitting the parts to the chassis to make sure I have all the necessary parts to complete a rolling chassis.
Hi again, I am also finding a bit of a problem to find a fuel sender unit with 6holes flange. Would the gauges be compatable with any unit. I have looked at sender units with a sliding float but with 5holes flange. Can you please point me in this direction.